Here is another one of those 'oddball' brands that were more than likely manufactured out in Eastern Canada during the late 1960's. Cobra amplifiers have a look very much 'borrowed' from the Blackface Fender heads during the same time period. An example can be seen below; it is the Cobra Model 800 MkII. These photographs were provided by reader known only as Chris Dayhoff of Boise, Idaho. Thank you Chris.
The first thing that catches everyone's eye is the 'Blackface' styling of the exterior. Unfortunately, that's where the similarity ends. Apparently, it was hoped that the looks alone would entice you over to this amplifier. It is purported to sound quite good, as I am sure it would, seeing that a simple tube circuit is used. The interior is nothing like a Fender, as evidenced in the photo below.
While the photographs did not turn out as well as I'd hoped (sorry about that), you can still see that the very sparse interior is really wired point-to-point, and no Fender-style fiber board is seen. It is also evident that the chassis is used as often as possible for a convenient ground connection. This was a common (although not recommended) practice by a 'stencil-line' amplifier maker from Montreal know as Pine Electronics. The concept of a 'stencil-line' is relatively simple; the amplifier maker produces amplifiers for 'wholesale' to virtually anyone who asks, and puts the buyers name on the panel. Usually, it is the same amplifier produced over and over again; only the front panel name is changed. Going back to the first picture, I have seen a few heads that look identical, with names on the front panel such as Riveria and Pepco. These may well be the very same amplifier. If any reader should have further information, it would be greatly appreciated. Finally, you may notice that the coupling capacitors inside the chassis are about the size of a Volkswagen. This is not unusual in older equipment, but is something you don't expect to see in an amplifier this 'young'. Perhaps the manufacturer bought surplus capacitors, or simply had them on hand from his days as a television/radio repair technician. So many mysteries, so little time.
The amplifier itself is pretty straightforward. It 'features' two 6V6's, two 12AX7's, and a 5U4 rectifier. The rectifier choice is unusual because a 5U4 is very 'over rated' for an amplifier of this power output. A 5Y3 would be more or less 'expected' to be used here. It is a single channel circuit, with a two-knob EQ. The lone Volume control oversees the three input jacks, labeled Guitar/Guitar/Bass. The 'middle' jack (labeled 'Guitar') appears to be the 'high-gain' input. When you draw out the circuit, it is very much like a Fender, albeit with a low voltage power supply, and an output of only about 15 watts. Other 'odd' points-of-interest I have noticed, although this is after only examining less than a half-dozen of these amplifiers is as follows.
There you have it. I usually see these heads for sale at very modest prices, and with just a little tweaking, they sound fabulous. You can think of it as a Fender Princeton in a head, but at a fraction of the price.